If you have any question or suggestion,
please call us:
Or send email to us:
sales@cnzhengge.com
  What's New
Your Location: Home > What's New
Water Shut Off Angle Valve Installation
Date:2012-6-11 13:28:12
 

Tips about Sanliv Brass Plumbing Angle Valve Installation and how to fix water shut off angle valves to copper tubing, plastic pipes and steel pipe plumbing supplies.
A lavatory/sink requires both hot and cold-water plumbing supply service. The water service plumbing is connected from the rough-in water lines to shutoff valves and from the valves to the hot- and cold-water faucets. When the rough-in plumbing comes out from the wall, use shutoff angle valves. When the rough-in plumbing comes up through the floor, use straight shutoff valves.
Installing shutoff angle valves to steel pipe. Use the following steps to install angle valve on threaded galvanized pipe (see Figure A):

FIGURE A. INSTALLING SHUT OFF ANGLE VALVE, STEEL PIPE
1. Check and clean the threads of the rough-in water pipe.
2. Slide the escutcheon on the pipe, and push it against the finished wall. Coat threads with pipe joint compound.
3. Screw angle valve hand-tight on threads, and then tighten with wrench. Make sure the valve’s other opening is facing up towards the faucets.
4. Set valve in closed position.
Installing toilet shut off valve to rigid copper tubing. Use the following steps to install an angle valve to rigid copper tubing (see Figure B):

FIGURE B. INSTALLING TOILET WATER SHUTOFF ANGLE VALVE, COPPER PIPE
1. Check and clean the copper tubing.
2. Slide the escutcheon, coupling nut, and compression ring onto the tubing.
3. Slide the valve onto the tubing, and screw the coupling nut hand-tight onto the valve. Tighten coupling nut with a wrench. Make sure the valve’s other opening is facing up towards the faucets.
4. Set valve in closed position.
Installing shutoff angle valves to plastic pipe. Use the following steps to install a shutoff angle valve to plastic pipe (see Figure C):

FIGURE C. INSTALLING WATER SHUT OFF VALVE, PLASTIC PIPE
1. Clean and apply primer around the outside end of the rough-in plumbing.
2. Apply solvent cement around the outside end of the rough-in plumbing.
3. Apply solvent around the outside of the smooth end of the male adaptor, and push it onto the end of the rough-in plumbing.
4. Apply pipe joint compound to the shutoff valve threads, and screw valve hand-tight into the female adaptor.
5. Tighten connection using two wrenches: one to hold the adaptor, the other to tighten the angle valve connection. Make sure the valve’s other opening is facing up toward the faucet.
This is the essential tips on installation of a angle stop valve, three angle globe valve, and how to install a crane angle valve.

 
Home | About Us | Products | News | Quality Control | Online Inquiry | Contact Us
Copyright©2017 Yuhuan Zhengge Valve Co.,ltd.   TEL:+86-158-67629659  FAX:+86-576-87148071
Designed by Tinnhoo Network Inc.